Posted by Crafty E-Liquids on


Once you’ve got your package of vape coils from Crafty E-liquids NZ, replacement will take just a few seconds. If yours is a top airflow tank then generally you unscrew its top portion where the drip tip is located; the atomiser coil is attached to the centre. Unscrew the atomiser head and discard it. Screw on the new atomiser head and attach the component to the atomiser.

If you have a bottom airflow tank, unscrew the base of the device and remove it. The atomiser coil will be at the centre of the base. Unscrew the coil and bin it. Screw on the new coil and screw back the base.

An unsaturated wick delivers a burnt taste and the coil can be ruined before you even start vaping. Once you’ve replaced your vape coils, drip e-liquid directly onto the cotton of the coil to ensure it is soaked through, break in the wicks by puffing on your device a couple of times to draw the juice to the wicks BEFORE activating the device. We also highly recommend letting your tank sit or stand upright for 5-10 minutes to allow the e-liquid to soak in.

Share this post

← Older Post Newer Post →

Leave a comment

Please note, comments must be approved before they are published.